Detent and HALO issues

[Lurker27]

I have a 2k2 LCD (single detent) with morlock board. I need to run a HALO B on it, but when I do it double feeds. What is the proper snapring/ram adjustment to prevent this? Failing that, what is the best detent to use with a HALO.

Finally, If the issue cannot be resolved, is it possible to drill and tap for dual detents?

I have an egg, and I do not want to run it. I need it as a back up hopper.

[Trance.]

I have a 2k2 LCD (single detent) with morlock board. I need to run a HALO B on it, but when I do it double feeds. What is the proper snapring/ram adjustment to prevent this? Failing that, what is the best detent to use with a HALO.

Finally, If the issue cannot be resolved, is it possible to drill and tap for dual detents?

I have an egg, and I do not want to run it. I need it as a back up hopper.

Try stretching the detent spring a little to make it stiffer, could help. or you could get a second detent installed

[Lurker27]

How do I disassemble a stock detent to accomplish this?

Also, does anyone perform the detent conversion?

[bigfootimp]

I am sure that one of the master techs could do the detent just give them a call and ask.

[Clipkid243]

id say itd be pretty easy
i think it goes where the jewel under the feedneck is, so just drill and tap there. im gonna try it soon

[tblevs55]

i know bob will do the extra detent its pretty cheap

[bigfootimp]

I've thought about doing it but i would only attempt it if i had a drill press. Just me though