rix123
06-25-2005, 08:59 PM
A couple of things I'd like to see for Force models that are pretty much "drop-in"...and a few others.
1) intelli-feed kits, i.e, : rails already drilled with cable installed, just replace existing rail and connect plugs to board/HALO. a variation would be to use 90* mini earphone type jacks that plug into back plate (or back of rail above back plate). HALO/EGG-2 set-up would be on owner...also allows for use of standard loader and still has "clean look"
2) multi-bore Infinity barrel kits, probably a 2-piece type that is "factory" color matched and retains same/similar profile as existing barrels.
3) harder spec anodizing, current scratches too easily.
4) lightened hammers to reduce "kick" resulting from cycling of mass. probably require matched springs for valve as well. a kit of 3-4 weights/spring rates would probably be good idea, allow diversity in tuning.
5) adjustable LPR, one that would not require current dissassembly-reassembly process, provide 'on gun' adjustability and reading.
6) spec sheet detailing all seal/o-ring sizes/types and which location used. sometimes you just have to get o-rings locally due to time constraints. Current kit offering lacks organization, all just thrown into zip-lock bag. spec sheet could be type that has actual "sized" picture on it where user can lay o-ring on it to match sizes.
7) color matched asa w/on-off ala DM5, EGO, etc. because the color scheming of Angels does not vary much, these can also be used/made available for older generation Angels.
8) cam operated feed neck, but with lever operation to rear to lock, sleeker profile, less likely to"snag it" and open at wrong time.
...as more comes to me I'll contribute to the discussion.
1) intelli-feed kits, i.e, : rails already drilled with cable installed, just replace existing rail and connect plugs to board/HALO. a variation would be to use 90* mini earphone type jacks that plug into back plate (or back of rail above back plate). HALO/EGG-2 set-up would be on owner...also allows for use of standard loader and still has "clean look"
2) multi-bore Infinity barrel kits, probably a 2-piece type that is "factory" color matched and retains same/similar profile as existing barrels.
3) harder spec anodizing, current scratches too easily.
4) lightened hammers to reduce "kick" resulting from cycling of mass. probably require matched springs for valve as well. a kit of 3-4 weights/spring rates would probably be good idea, allow diversity in tuning.
5) adjustable LPR, one that would not require current dissassembly-reassembly process, provide 'on gun' adjustability and reading.
6) spec sheet detailing all seal/o-ring sizes/types and which location used. sometimes you just have to get o-rings locally due to time constraints. Current kit offering lacks organization, all just thrown into zip-lock bag. spec sheet could be type that has actual "sized" picture on it where user can lay o-ring on it to match sizes.
7) color matched asa w/on-off ala DM5, EGO, etc. because the color scheming of Angels does not vary much, these can also be used/made available for older generation Angels.
8) cam operated feed neck, but with lever operation to rear to lock, sleeker profile, less likely to"snag it" and open at wrong time.
...as more comes to me I'll contribute to the discussion.