Removin the Ram

[Blackhand]

Ok fellas whats the easiest way to remove the ram on this baby. I followed the directions on the manual and i stilll cant lift the back plate off the G7. This is what i did so far. Opened the breach. took the small screw out of the breach opener, took that middle screw out of the back plate, then it says i should be able to lift the plate off. Im pretty much stuck on that step. I Cant lift the back plate off for some reason. Am i missing somethin? Whats the easiest way u guys have found to remove the Ram?

[El Pirata]

Pull the back plate straight back rather than lifting up, remember you have wires arrached to it so don't pull to hard or far. If you have the breech lever removed and the center screw on the back plate it should come off.

[Blackhand]

Thanks man. I havent done it yet but i will eventually do it, but i have another question after that step of removin the back plate can u know remove the ram or is there more screws to remove before u get to that step?

[Sparco]

You'll need to remove the trigger frame from the body. There's a pin that extends up through the body which keeps the ram secure in place (since its not threaded). After sliding this pin out you can push the ram out (or pull).

[El Pirata]

The pin is in there tight so you will need a pair of pliars.

Speaking of pins, I have not had a chance to get with Rob about your pins Sparco, I will this week or weekend.