Quick Question

[Paused]

well I thought I'd post this question you the members of AOG, since it can't hurt. I traded for an Angel A4 Flied, when I recieved the gun it worked flawless. I start playing in some scrims, nothings wrong. Around the end of the day it starts to bounce uncontrolably going on full auto basically, this happened twice. I have a MT trigger and magnet mod along with it. I have my Tr set to 1. I'm just wondering why this is happening. The previous owner said that this had never happened to him once. Any insight would be greatly appreciated.

thnx,

[Kerdon]

A set screw may have wiggled loose.

[paintreliever]

^^ i concure

[Clowndog]

Try checking your TOE screw,, the one in the "middle" of your trigger, It has a tendency to move unless properly "stuck" with a SMALL drop of loctite.

[Paused]

well checked the set screws but it's still really bouncy but only went on full auto once, this last practice = improvement. Just a question but would temperature effect the trigger with the mag. mod, b/c it is extremely bouncy? We're looking 30 degrees Celsius (roughly 86 F) and humid.

[BoB]

Do you have a fly board or euro? Is your toe screw touching the leaf spring when at rest?

[Paused]

my toe screw does not touch when at rest, it has about a millimeter of space, i'm not sure if that's good or bad...

[Kerdon]

my toe screw does not touch when at rest, it has about a millimeter of space, i'm not sure if that's good or bad...


That is bad, your trigger screw that touches the leaf spring has most likely pushed the switch sensors out of alignment. take the board out and make sure that the switch sensors are 90*perfect.