drive cone rubbing

[dukduk]

does anyone's drive cone rub on the 3 gearbox screws

[rix123]

...re-check your assembly, you may have something assembled out of sequence, preventing the shaft from protruding completely into the body...

..another possibility is the gear box halves are not seated correctly or the gears themselves were not assembled correctly preventing the gear box halves from fully seating correctly...

...also, re-check the screws themselves to ensure they are properly tightened..

...this is all presuming that had disassembled your HALO

[dukduk]

everything is put together...i checked and rechecked a few times, even reverse engineered with my roommates who bought his rip drive installed

i think the problem is that the gear box screws are protruding too far and touching the drive cone. i'm sure that everything is in the right place but there is some slack in the rip drive/shaft/drive cone.

yea i did disassemble to install a rip drive...

why i didn't get a halo b with rip drive installed(b4 anyone asks!):
my shop didn't have a ripped halo. i had to buy one right away becuz one of my pare's wanted to play the weekend after i got my rasta. the plan was to wait on a angry board and a halo b w/rip drive but i needed a loader