Breech wont close

[flyballa04]

i was shooting my fly in the back yard and when i was done i went to clean the bolt i took the bolt out and cleaned it then when i put the bolt back in and went to close the breech it wouldnt close the bolt wouldnt allow it to close all of the way. Any suggestions on how to make it close? :notsure:

[Klassy Guy]

Ram is too far foreward, adjust it.

[active8951]

Ram is too far foreward, adjust it.

yea and make sure when you close it you have that little stick part of the bolt inserted into the gap thats on the ram.

[ShadowWolf]

That happens to me quite often, it has never been anything I've had to "adjust" though. Sometimes the ram doesn't get enough air to cycle back into position. Just gas it up again, turn the air off, and slowly shoot until the airs out of the gun. Only takes a second or two.

[orionuser]

try sliding the bolt back and forth to and try to close it then it may take a few tries this happened to a guy at the field and i helped him with

[flyballa04]

Yeah the ram was too far forward. I adjusted it works fine now ;) thanks