loader or me???

[phil2]

Hey guys I have a rasta fly.I cant go through a hopper without choping a ball.I have a empire b I have tryed it on speeds 1through 3.Marker set on SF.I am sick of my strait shot and cleaning goo!! Any ideas???

[Benfrain]

99 times out of a 100 it's the paint you are using. If your loader is set to speed 1 (slowest) and your loader speed is set to FAST or SFAST on the Fly and you are getting chops it's VERY probable it is just your paint. Try a different brand and batch before you mess with ANYTHING on your marker. Let us know the results when you have done that.

[G-FIZZLE]

clean your eyes

[G-FIZZLE]

or there breaks paint to barrel match

[FAIce]

yeap change paint!

[phil2]

Thanks guys I get stuck using severe but guys with other types of markers were not having any problems? Plus they are not hitting 20bps either.

[Benfrain]

All we are saying is that Paint is most probable cause. Just try 500 Draxxus blaze through it and tell us the results. It doesn't matter what was happening with the other markers.

[Elren]

Also make sure your ram is adjusted properly.

[corrupt123]

check your barrel. if it's as bad as it sounds you might have a burr or something just shredding all the paint.

otherwise, as mentioned, make a checklist and check it all over, trying anything else you can right down to the paint, loader, and barrel.

[-=Pandemonium=-]

another thing... i was chopping for a while.. did everything everybody told me i should do and nothing helped... so i changed my detents and detent springs.. no more chops!!!

[phil2]

let her rip today put it on fast, empire on speed 3 and oh my no brakes!!! put a case and a half through it, ramps though?and drop off like crazy.Dwell 11 trs 18 bulldog 450output 68 3000 I can tell its starving for air. tank? gun?

[Elren]

You say it ramps, your TR is too high. Lower it below 10 to remove the extra shots. Does it drop off all the time or just after sustained fire? It might be a matter of recharge rate.

[phil2]

no it only drops when i get on it and it starts to ramp.

[WDP ir3 2k3]

See what your LPR is at yours might be to low

[phil2]

I cleaned my lpr and it shot fine for about a half a case then the drop off started again. i can here the marker recharge after i stop shooting??? I have no guage and one shim in the lpr.

[Elren]

Well you'll probably need to get a tool kit to check your LPR but maybe your mini reg needs to be greesed. If its recharging slowly try that.

[phil2]

I'm lost cleaned and regreesed. one finger on trigger put one ball right behind the other.Hit anything over 10bps drop off I dropped my trl to 8 to slow it down,dwell at 11.Could it be the volumizer?? i have the big one on. Or could it be the bulldog not keeping up because the marker is so damm fast?

[Pookapants]

I would also change the battery in your hopper.

[Eclipse363]

try your gun with a new tank, if thats not it, then new hoses, if thats not it, rebuild the minireg, if thats not it, its probly the lpr