intelefeed help

[p8ntfreak32]

Hey just did the mod to my halo for intelefeed I followed all the instructions, the board is on the right settings, and for some reason when its on the gun and we pull the trigger, instead of just spinning alittle it will spin alittle to much then the second shot, it will just keep going and not stop.

Any ideas?

[bigfootimp]

I had the same problem and the best that i could figure is that the reed resister just gets stuck. I didn't have time to full with it because of tourneys so i just put my reloader back the way it was

[pimpinsaylor]

did you do it yourself or did you get it jaloed by jim at impact?

if jim did it he can help you. if not just pay the $80 bux to get it done by jim (he's a good guy)

[rix123]

Hey just did the mod to my halo for intelefeed I followed all the instructions, the board is on the right settings, and for some reason when its on the gun and we pull the trigger, instead of just spinning alittle it will spin alittle to much then the second shot, it will just keep going and not stop.

Any ideas?


...you might want to check the "HOP" settings in the advanced menu selections... you may have too high a time duration setting imposed....

...the higher the number, the longer the spin. Ideally, what you want to do is set it to spin just enough to keep the ball stack full. It is conceivable that the speed of your trigger pulls can be such that the signals 'overlap', accumulating to the point that the signal keeps sending, hence keeps spinning.

..some set the hopper parameter to the lowest setting, some set to get it to spin in 1/4 turn increments (depending on thier individual marker), i.e., one quarter, one half, three quarters or a full turn of the cone for each pull (signal) of the trigger. The time duration is what allows the cone to sping as far/long as it does.

You may also ant to check the type of relay your using...some have had sketchy problems with the 'reed relay' types due to the center wire shifting back & forth...

[jayr7309]

...you might want to check the "HOP" settings in the advanced menu selections... you may have too high a time duration setting imposed....

...the higher the number, the longer the spin. Ideally, what you want to do is set it to spin just enough to keep the ball stack full. It is conceivable that the speed of your trigger pulls can be such that the signals 'overlap', accumulating to the point that the signal keeps sending, hence keeps spinning.

..some set the hopper parameter to the lowest setting, some set to get it to spin in 1/4 turn increments (depending on thier individual marker), i.e., one quarter, one half, three quarters or a full turn of the cone for each pull (signal) of the trigger. The time duration is what allows the cone to sping as far/long as it does.

You may also ant to check the type of relay your using...some have had sketchy problems with the 'reed relay' types due to the center wire shifting back & forth...


Go to the Hopper setting on the gun and set between
.05 - .20 what ever is confortable for you

[p8ntfreak32]

ok thanks ill try it out