A couple of LCD questions..(new to angels)

[Zeroack]

A very good friend dug his LCD out of his closet and gave it to me. I added a ccm mid-rise feed neck and ccm on/off and minidrop. It's a nice look'n little marker.

I turned it on and gassed it up. I pull the trigger three times and I get one pop...then I can hear something inside reset. I added a few drops of oil to the asa and a couple in the breach. This seemed to help a little but it's still sticking. Will I need to be picking up a angel tool kit and cleaning and oiling the valve and such?

Next question...will matrix grips work on a lcd? I thought I'd seen them on one before.

thanks

Zero

[FencerSMS]

wel... your problem there. it could be everything from stuff that you need to adjust with an angel tool kit (or just drop it off at your local MT), or it could be something like in need of some new orings + cleaning. check the settings on your LCD screen too. make sure everything looks in order before you do any internal work.

matrix grips, know someone wit a trix? try them on your gun. i doubt ti though, the matrix frames seem alot bigger than the stock LCD frame.

[Zeroack]

Well forget the Matrix grips. PBgear has dye stickies on sale. I'll pick up a pair of those.

I'm in the middle of nowhere so dropping the LCD off for service isn't gonna happen. I'm a pretty decent at getting things working if I have the right tools.

I'm gonna look at the settings today and hopefully rule that out as a cause. If it's not it then I'll order a oring kit with my stuff from pbgear.

Zero