Minireg Pressure

[snoop]

Hey, 1 how an i change the psi of the minireg, and how can i tell wat it is? :notsure:

[shaq787]

to change the pressure of the minireg just use a 3mm allen key and turn the screw. check the manual for which way increaces and whice way decreaces. to check the operating pressure use the pressure gague that comes with the angel tool kit and just screw in on. dont fire fast while it is on there, ive heard that the needle will snap off and dont leave it on while you are playing.

[snoop]

not FPS i needa know the PSI of the minireg.. also not the psi of the LPR i know how to do that ( i have an evolve kit aswell )

[shaq787]

changing the PSI changes the FPS. its the same screw, the higher the pressure the faster the ball. and you can put the pressure gague that is used to set/check the LPR and put it on the valve side to get your operating pressure - that is the one that effects the velocity of the ball. if that is not the answer you are looking for then you should rephraise the question, it wasnt that clear to me.

[El Pirata]

The only way to check the pressure coming off your mini reg is to buy a 0-300 pressure gauge and replace the lpr pressure gauge with the 0-300 gauge. Once you do this then unscrew your exhaust valve cap and put the gauge assembly in there then turn on the marker. Now this will tell you how much pressure is coming off your mini reg.

[snoop]

iight so i need a 0 - 300 psi gauge.. with like a smal screw in spot? for the minireg?

[snoop]

sorry i didn't make sense shaq but idk how i would rephrase the question? :-\

[El Pirata]

iight so i need a 0 - 300 psi gauge.. with like a smal screw in spot? for the minireg?No, I was refering to the one that's in the Angel Tool Kit that every owner should have invested in: http://www.angel-owners.com/showpost.php?p=322029&postcount=45

[snoop]

i got that gauge.. but that is for the lpr yes?

[snoop]

oh do you mean the other side?? valve side?

[shaq787]

yes. when the gague is put on the valve side it will tell you the operating pressure.

[snoop]

so i need a 0 - 300 psi gauge to fit on the toolkit peice..? yes?

[El Pirata]

so i need a 0 - 300 psi gauge to fit on the toolkit peice..? yes?Yes, exactly. I added a couple of fittings to make it more user friendly to change gauges. I'll probably get Dezign to make me another one so I don't have to change gauges and just have 2 different tools.

[snoop]

iight well idk it would be nice if i could just buy one .... for like 15$ or w/e so lemme know if i can :) thanks :cheers:

[N4XPLAY]

well if the preshure u need is with in the range of your curent gauge then your there
most of the tool kit gages top out at 160 psi some go 190 or 200 if im not mistaken but good luck