Trigger Bearing Problem

[blingintippy]

I keep having a bearing problem with my trigger. The bearing will spontaniouslt pop out a bit while in the frame. This causes the trigger to rug against the frame a little bit and cause friction. It slows me down like crazy. N e one else get this problem? Help!

[eric111e]

did u tighten that screw down that holds it in?? is that screw even in there?

[blingintippy]

did u tighten that screw down that holds it in?? is that screw even in there?

yea those are tightened . The problem is when they are tightened the tigger moves side to side on the bearing get it? im gonna try and take some pics but i cant now cause im goin balling! lol lata

[SiNaR]

Check the cables form selenoid and switch. Maybe they are to close and disturbing trigger to move slightly. Try also screw a little bit more the first magnet and unscrew second, to replace trigger - move - area.

[blingintippy]

That made absolutly no sence. The noid/switch wires come no where near the trigger. They are housed in the LPR-side cyclinder and only part that come into the frame are attached at the top of the board. Wat does trigger move area mean? I no how to relplace a trigger btw it isnt that hard but. third, u cant unscrew the magnets and even if you could that wouldnt do n e thing to help the trigger stop moveing from side to side on the bearing... thanks anyway