MT Valve?

[Method Acting]

i was just browsing through PBN and saw someone speaking of a 'MT valve' that he got and now he can get his LPR down to ~35psi

i wanted to confirm that:
-this is a real valve and im not a a wild chase
-real angel owners have tried this with sucess

[Studmuffin]

i know there is an mt valve(go to an mt site they may have them there) but don't know about the 35psi setting.

[Sparco]

The MT valve (to my knowledge) is the actual stem, not the guide. As for the 35psi, I know Jouster runs his MT A4 at something like 38psi. That's with the diverter plate! So you have to figure that without that diverter plate he could run it even lower.

[GusTopher]

I saw this today on PBN as well... I never listen to anyone over there though! I was going to check here too! :cheers:

[Snowfire]

I have a fever...

[thog94]

The MT's made both a valve and valve stem. Ken only recommends that you use one or the other and not both together. I have no idea why, I'd ask him or another MT about that. As far as being able to drop your pressure down to 35psi, that's all gun dependent. I have one in my Force and have fooled around with pressures as low as 45psi and it seemed to run without any problems.