sssss goes the tank.

[kemp]

Hey i have been working on an efficiency problem with my angel led. I have almost got it nailed. I blocked off the AIR ASSIST valves that went to the 14 way. Now when im playing everynow and then i can hear a "sssssss" from the macro line, the section that attaches to the check it unimount. I can pull or push on the macro line and it will stop, but after play i can hear it hisssing at me again. Do ya think the macro line is fubared or i suspose I have not installed the macro line correctly any hints or tricks to stop this problem.

Thanks, Kemp :drink:

[Vantage_TeS]

Degass and pop the macroline out and check the end. If it's not cut square or there are gouges try cuttin a small section off and putting it back in the fitting.

[kemp]

will do thanks abunch!

[kemp]

errrm i pulled on the dang macro line until i made my unimount go wobbly.... any trick to getting this %^&%$ hose out?

[El Pirata]

You need to push on the ring on the macroline fitting while pulling on the macroline. If you are not able to get enough leverage on the ring use a cresent wrench opened to just a hair bigger than macroline and use the cresent wrench to hold the macroline fitting ring and that should work just fine.

[kemp]

oooh i see thanks El pirata.