Important question

[CanadianGuest]

On the angel on the left side, they have the pin that holds the eft side of the breech in place so the breech can pivot and open. How the hell do I get that pin out, does it screw out, or should it fall out?

[FencerSMS]

ya, im wondering the same thing actually. mine has all this gunk and crap on it, and i wanted to clean it, but i cant figure out how to get it out. as long as the breech keeps opening, i guess ill have to wait until someone can answer that question

[nonamifrontman]

I know that there is a hole in the pins that is threaded, I went to the hardware store today but with no luck, they didnt have a small enough diameter... Ill try again tomorow at another store and let you guys know the thread size unless someone posts it before I do.

[Vantage_TeS]

The long screw from the LCD 14way is the proper threading. The only thing is you will most likey ruin the screw pulling the pins. If you took the screw to a machine shop etc they could match the threads.

Oh and to get to the pins there is a grubsrew that is loctited in.

[effbee]

The screw is a 1.5 Milimeter. I had to get one from the local supply house. Chances are that the pivot pins are badly corroded as well, and it will take some serious muscle power to get them out, even after a soaking with WD40.