Programing the mini morlock board

[THE BEST LED]

I have just recently bought the mini morlock board from KM2 and I dont know what settings to use for it. Also my eyes do not work like they should for some reason (I turned it on beam break). This is what happens exactly:
I turn the gun on without any air
The gun doesn't shoot very fast when I pull the trigger
I put my finger in the breach and the gun ripps
This is all how it should be!!!
when I shoot the gun with air in it and no paint and it is a hole different story
the gun just rippes as if it had paint
I tried it with paint and it choped a ball
PLEASE HELP ME

[nonamifrontman]

http://exarin.com/products/morlockman.html

Here's a link to the manual, my board will be in today and I'll let you know if I have an problems with it.

Do you mind taking some measurements for me? How far from the breech you put your eye holes and all that good stuff? It would be very much appreciated.

[THE BEST LED]

For the actual eye hole it is between 5 and 6 sixteenths of an intch high from the breech and 3 sixtheenths to the left from the breech (on the left side of the gun.)
If you want a hole for an eblade eye cover than the demintions are 10 sixteenths high from the breech and 3 to the left. It is the same on the right side of the gun. The eye hole size is one eighth of an intch.
Be carefull with this because my angel has costom milling on it (Adrenalin). I am almost positive (99%) it will be the same but don't blame me if something goes wrong.
By the way I need to know the settings for the mini morlock board and not the morlock board.

[nonamifrontman]

Do you mind taking a pic of your gripframe, I wanna see how you mounted the board, where you put the battery etc...

How did you route the eyes?

[THE BEST LED]

Sorry but I don't have a camera and I also did not do the routering myself. Warped air smithing did it for me. I put the board where the old battery use to be and so the 9 volt battery is the only thing in my gripframe.

[Mindjob]

Bob from TAG told me the only board setting that needs changing for the LED is the dwell for the vavle. I believe it should be 14.

Here is the link. There is also lots of good info on the TAG sight

Linkage (http://www.tagsportz.com/forums/showthread.php?t=2885)