nonamifrontman
03-20-2005, 03:19 PM
I'm takin my LED apart to install my Morlock board an get it annoed soon... There are two setscrews that are slightly rusted and I can't turn them at all... one is right next to the slot for the wires and right in between the two tubes. The second is the setscrew that closes the central air passage at the back of the marker...
Any ideas how I can get them out? I put quite a bit of Liquid Wrench Super Penetrator on it over the last few days hoping that it will free it... I dont think there is Loctite on it seeing as there wasnt any on any other setscrews I took out...
Any ideas how I can get them out? I put quite a bit of Liquid Wrench Super Penetrator on it over the last few days hoping that it will free it... I dont think there is Loctite on it seeing as there wasnt any on any other setscrews I took out...