So many problems with my 03 speed

[screwedupmonkey]

well, i bought my gun used and i shot it once before and it worked fine, but today i went ballin and had a buttload of problems

1- My gun would not get above 200 fps, i messed with teh velocity adjustment, but nothing would happen it would shoot between 100-200fps, almost as if the balls were rolling out


2- When i would open my breach and wipe the bolt down, the breach would not close again, i had to gas it up everytime again just to get it in, i dont know if its a problem, but with my firneds speed it never happens

3- My breach knob and the the pole thing_the thing that keeps trhe break closed) wont stay still, it slides back and forth during games, or when im just holding it, i took it out, and theres no spring in there, could this be teh problem?


Any imput and directions on how to fix this would be greatly aprreciated, im thinking about sending it off to wdp, but want to get it fixed by myself

[Paintballjc]

sounds like your ram may not be adjusted right. Also, what are your Dwell and LPR settings?

[Sloffie]

Yeah i think it could be that the guy who owned the marker before you adjusted the ram improperly. And yes there should be a spring to reset the breach nob.
But to help with the velosity problem you gotta know the settings.

[screwedupmonkey]

my dwell had the first 3 green lights, so im guessing it was set around 9-10, and how would i adjust lpr pressure? or adjust teh ram?

[Vantage_TeS]

You would need a toolkit for these.

www.angelforce.tv for the closest Master Tech for a basic tuneup.

[firemedic30]

You will need the Angel tool kit.

1. to check the LPR, take the end cap off, replace it with the LPR gauge and air the gun up. The gauge will tell you what the pressure is. The optimal pressure is 82 without a volumizer.

2. With the gun GASED UP!!!!......take the back plate off and with the ram adjusting tool from the Angel Tool kit, rotate the ram clockwise ever so slightly until there is a notable click when the breech. The rod in the bolt should between the ram grooves. The click is than bolt fitting in place.

[Luzrd]

1. whats your input pressure. battery fully charged (you cannot trust the gauge on the board)? and knowing your settings will help. you should get a toolkit it makes life much easier for you.

2. not a problem, just an inconvience for now. adjusting the ram will help (again toolkit makes it easier) proper adjustment is outlined in the manual.
(hint) with the gun off, barrel removed, and hopper installed and on. look down where the barrel goes, and make sure the second ball in the stack isnt protruding (too far) into the breech. the breech should click when closing it when properly setup.

3. yeah theres sposed to be a spring in there. without the spring the breech may open while your shooting. (probably not if the ram is as far forward as i think it is though
= }

[welted]

1- My gun would not get above 200 fps, i messed with teh velocity adjustment, but nothing would happen it would shoot between 100-200fps, almost as if the balls were rolling out

if screwing in/out the screw on the minireg doesn't do anything, then that's a problem. take the mini reg apart (see the manual), clean it and lube it and make sure everything seems good. reassemble and test.

as a last resort, you can send it off to an MT to get it running in peak condition.