Blender!!!

[angelguy3]

Ok so I was shooting my Speed yestersay and it shoots, but not good. I had Sensi on but it was on mode 1. And I was shooting competitive edge paint(Which I didn't think was horrible,but I know it's pretty bad). I usually keep Sensi on mode 2 but somehow it was on mode 1. My speed usually never chops. Help! Oh and my dwell was on 12 or 13.

[P A C 1]

charge your battery, and do the sensi test... and see what happens

[welted]

also, make sure that your ram is adjusted properly...

[ropesofpaintxxx]

see if it was the chop hitting the paint and making it break , make sure u see what it is first, the shell could of suxed with that paint and it could of busted when the bolt it is, maybe sure that the ram is to were the bolt is like 1 mm behind ok

[angelguy3]

I know I did a Sensi test and it's working fine. I would ajust my RAM but I'm not to good with tinkering with stuff and I don't wanna break it. Do you think it might be that my Sensi was on mode one and I usually have it one mode two? Ok I'm gonna start by battery charge now. I know it's not a big problem. :piss2: :canada:

[angelguy3]

Ok, I went to charge it and when I put the plug in the board moved with the plug. It still is charging fine but is this normal? :notsure:

[*I*A*]

are you sure it was chopping and not a barrel break? i have allways used mode 1 and havent had any probs with it

[lilmike]

i chop less when not in sensi...i was shootin a hopper off into a frozen creek tryin to break the ice w/ crappy paint shootin ropes and i didnt chop one..but when i go into sensi i chop more...but my settings might be all messed up...

[angelguy3]

Maybe it was the paint it was 32 degress yesterday.?

[angelguy3]

Can the ram just come unajusted randomly?

[Clipkid243]

not usually, make sure that its an actual chop and not a barrel break. you shouldnt be able to chop using sensi 1, but it being around freezing probably had an effect too.

as for the board moving, just open up the grip panel and tighten the two phillips head screws.

[speed demon 666]

hear sum tips mode 2,dwell high,make sure u LUBE THE RAM OR IT WILL BREAK EVERY BALL, and check if u ball detents are okey and paint and right barrel,lube ur mini reg and check if ur sensi is in the breach far enough and working

[angelguy3]

I think I know the problem. It was about 30 degrees outside and the paint should only be in 55-75 degree weather.

[Robcsmall]

I think I know the problem. It was about 30 degrees outside and the paint should only be in 55-75 degree weather.

:stooges:

Could be...

Setting the ram forward in to the breach area fixed my problem... Can't open the breach any more.

Just unscrew the back plate to expose the ram adjustment bolt. Use the special ram adjustment tool.. clockwise for in, Cclockwise for out.

I don't brake/chop paint, so no need to open breach.

[three fut nuthin]

its most likley the paint man. make sure the balls werent breaking in the breach, but in the barrel.

[Klassy Guy]

Use a volumizer, lessens the bolt to ball impact, which will allow your gun to perform better in colder weather, and warmer. The temp probably did have an effect on the paint though, so I wouldn't worry unless you live on the north pole, and weather doesn't get warm.