PDA

View Full Version : need help asap 05 speed is not working!!

weeman2
02-20-2005, 04:58 PM
ok heres my problem my angel will not fire it only makes a pop noise when i pull the trigger. i have tryed every thing i can think of in clueding addjusting the the reg and input presher my reg is wide open and i had my angel air put up too 550psi in to the gun and it still did it i need help.
shaq787
02-20-2005, 05:21 PM
what is your lpr set at? if its too low then the hammer will not have the power needed to open the valve.
DustSilverAngel
02-20-2005, 05:28 PM
Not being funny have you checked your battery ??/
El Pirata
02-20-2005, 05:53 PM
what is your lpr set at? if its too low then the hammer will not have the power needed to open the valve.
That's got my vote. The higher the input pressure the less and less you will get out of it if the lpr is too low.
weeman2
02-20-2005, 05:54 PM
i did and it's new also i donno the lpr setting. i'm new to angels i just got htis in december so bare with me.
weeman2
02-20-2005, 05:56 PM
also how do i adjust the lpr and so i need a sertain tool for that
Tantrum840
02-20-2005, 06:24 PM
have you taken your solenoid off and put the gasket back on wrong ?
weeman2
02-20-2005, 06:36 PM
i might have i'll flip it over and see if it works or side ways and stuff
weeman2
02-20-2005, 06:54 PM
it was the gasket thanks for ur guyses help
Tantrum840
02-20-2005, 08:05 PM
anytime