Blender!

[Nicholson]

my buddies got an angel ir3 with the following:

68/4500 HP maxflo
Mini reg
halo B with rip
ultralite

it is very hard to get this gun to shoot fast without it chopping... any ideas what could be wrong? hes used different kinds of paint and a revy but no luck HELP!

[Paintball is Life]

You could try the softface bolt that should help other than that IDK. cause normally thats a Halo Problem.
Robert

[Nicholson]

You could try the softface bolt that should help other than that IDK. cause normally thats a Halo Problem.
Robert

he is running maxflo and he doesnt know what the pressure should be on the maxflo... any ideas? and he hasnt maintained this gun at all could that be a reason why its chopping?

[angelguy3]

use a new loader,he may be shotting to fast for the revy

[Nicholson]

we've tried a halo and a revy it chops with both shooting slow

[Specialblend2786]

where is it chopping?

or rather, are you sure they arn't all barrel breaks? os the bold actually slicing the balls?

[Nicholson]

where is it chopping?

or rather, are you sure they arn't all barrel breaks? os the bold actually slicing the balls?

well there is paint all over the bolt and in the breach so im pretty sure there chops

[Rogue_Force7227]

What kind of bolt is it ? Check to see if there is alot of roll-back in the breech. I had the same problem with my ir3 before i got a jam bolt.

[Goryevilkitty]

Tell him to put the dwell at 14. Also tell him to make sure the LPR is around 85psi or 6 bar.