Magnets

[SpEeD187]

my back magnet will not let go of the trigget i read the manual and it say the big magnet gose on the back.. now when i oput the big magnet in the fron it works but i can not move my dials to set my trigger at all some 1 pls help me

[El Pirata]

First off if it says the big magnet gors in the back why did you put it in the front?

Is the set screw holding the vernier knobs tightened? Did you assemble your trigger with the vernier knobs in the stock position or the previous position? Did you assemble the pins in the correct place?

[Speed Ninja]

I dont know what the problem was but i took it apart a gain and fixed it but thanks

[El Pirata]

I was doing a little trigger tweak this afternoon and found that my big magnet was in the front coming that way from WDP. Interesting...

[chirogator]

Mine was that way too!

[SpEeD187]

so is this normal..
I orderd my vernier trigger wheel set from
fixmyangel.com i will see what happens when i put new 1's on

[aznazsnipr]

I also took my frame apart today and found that the big magnet was in the front instead of the rear from WDP... I also found that the rubber washers that people are taking out that were suppose to be on the metal rod that pivots the trigger by the two lil hex screws were also not installed from WDP.... QC problems ??? :notsure:

[DWOOD]

they started leaving the ruber washers off cause everyone took them off anyway. they just included them with the gun. my magnets came with small in front big in back, i switched them to big in front small in back. lot smoother now. mayb they r doing this from the factory to save people less hassle since most do it anyway :notsure:

[lliilljjoohhnn]

where r the rubber washers