Help!

[Speed Ninja]

i took off my whole trigger frame and its fine but one BIG problem. When ever i start walking it my trigger gets stuck and i have to quickly push it back out. I dont know what is wrong HELP PLEASE :cry:

[ZoomZoom]

i took off my whole trigger frame and its fine but one BIG problem. When ever i start walking it my trigger gets stuck and i have to quickly push it back out. I dont know what is wrong HELP PLEASE :cry:
have you greased your roller bearings on the trigger

[El Pirata]

Did you not put the pins back correctly on the top of the trigger? Did you forget the magnets? If so then replace the magnets. Is your trigger adjusted too far forward and gravity and the magnets are forcing it to the rear?

[maybachgt]

mabe the pin is rubbing against something else.

[ZoomZoom]

or you over tightned the screws that hold the trigger

[ORRACLE GANGSTA]

is one of your rubber washers next to the trigger pins pinched and causing to much friction?

[Speed Ninja]

I put oil on and it dose it less but it still dose it at least one every hopper pull

[El Pirata]

I noticed this afternoon while removing my rubber washers if I put my trigger too far forward using the vernier wheels it could stick in the rear position. If I moved the trigger back a little it didn't stick. Perhaps you could try that.