eyes are not working on 05 speed

[Towel1]

my eyes are not working properly they show there is a ball in the chamber even when there is not and then i pull the trigger and it shows there is nothing thetre with the lights and a couple seconds later it goes back to showing a ball is loaded even when there is still nothing there i have cleaned my eyes a couple of time and still nothing i was wondering if someone could help me with my problem

[masterdebater]

my eyes are not working properly they show there is a ball in the chamber even when there is not and then i pull the trigger and it shows there is nothing thetre with the lights and a couple seconds later it goes back to showing a ball is loaded even when there is still nothing there i have cleaned my eyes a couple of time and still nothing i was wondering if someone could help me with my problem

hmmmm... I knew there had been problems wit does eyes. Refer to page 5 in ur manual. About the sunlight thing. Where if you take ur hand off the grip the safety feature activates and you stop shooting. Any way you may have defective eyes. Try those new laser eyes. Then you can say,"My gun has fricken laser beams in it!"

Hope this helps, probably not much. Later

[ZoomZoom]

i would say to clean your eyes and change your batt. first and go from there

[winter001]

hmmmm... I knew there had been problems wit does eyes. Refer to page 5 in ur manual. About the sunlight thing. Where if you take ur hand off the grip the safety feature activates and you stop shooting. Any way you may have defective eyes. Try those new laser eyes. Then you can say,"My gun has fricken laser beams in it!"

Hope this helps, probably not much. Later

Read what the manual says before giving advice, the part about sunlight pertains to the opto board, this has NOTHING to do with the eyes!

Are you experiencing this problem when there is actually paint in the gun or just if you are sticking your finger into the breech?

[canyouspellthis]

sounds to me like your eyes are dirty, take them out and clean them and try again..

[sarconi]

i just had the same problem, i had to get new eyes because the cabel was faulty

[speedjunky777]

im havin the same problem but i think mine might be due to a creased eye ribbon so take ur eyes out and the ribbon and make sure its not torn and there arent any creases of folds in it.

[Towel1]

i have cleaned theyes and changed the batrtery and i am experiencing the problem bith with paint and sticking my finger onto the gun

[big azn]

Did you take them out and clean them with a fine cloth or just used the air pressure cans because i used to have that problem for a like a day and I fixed it by taking them out and cleaning them and also putting a new battery in.(the can did not clean my eyes)

[maybachgt]

clean them with an eyeglass cleaner I had the same problem. Sometimes finger oil gets on them.

[El Pirata]

For cleaning eyes I personally use an air compressor. 40 psi is more than enough to blow whatever crap is on the eyes into oblivion. The best part is that you don't even need to remove the eyes to clean them. True labor saving device.

[ORRACLE GANGSTA]

i pop the eyes out and use a q tip. Works great. I think your trigger adjustment screw needs to be backed out. I think that will work for you

[El Pirata]

Good call.

[JAMES-G22]

In my house i remove the eyes and dip them in alchohol, on the field y sray it .

[El Pirata]

Not too sure how the plastic components of the eye will react to being dipped alcohol. Might be interesting way to find out though...

[ZoomZoom]

rubbing alcohol wont hurt plastic it comes in a plastic bottel

[El Pirata]

Hey there buddy there are hundreds of types of plastic and I am guessing the eyes are a acrylic based whereas the bottle that the alcohol comes in is not.

[ZoomZoom]

omg oh boy my dad is a chem engineer he said as far as alcohol goes plastic is plastic he says if its not toxic enough to damage your skin it wont damage plastic

[El Pirata]

I know the feeling. My brother it a plastics engineer and tells me everything you never wanted to know about plastic and wish you had never asked.