Valve removal without tool kit???

[saucey360]

Is there any way to take valve out with out an angel tool kit. because my valve is facing the wrong dirrection and it wont let me raise fps because the hole in the valve is turned down.

[JDemonpbt]

yes there is. You need 1) a metric bolt, w/ a 2.5 mm tread, and 2) a pair a circlip pliers. First degas the gun, and take off the left hand side end cap, using a 4mm allen key. This will expose the LPR piston. Use the 2.5 mm treaded bolt to screw into the piston, and slowly pull it out. Becareful not to lose any shims, or stack springs. This will now expose your valve. Next using a 2.5 mm allen key, remove your back plate. Becareful not to lose the spring to your breech rod. Use the circlip pliers, unscrew your ram, and remove it. (Your hammer is attached to ram) This will now expose the back side of your valve. Use a (I recommend a swab or stick squeege) to push out your valve (provided your LPR and Valve Guild locking pin has been removed, both located under the main body of the gun) turn your valve stright again, and reassamble the way you disassembled. You should be good to go now, provided your LPR pressure is set right. (95psi)

[KEN CRANE]

remove the ram and use a dowel from the rear....