old valve screw dosnt equal new valve screw

[sharps990]

its kinda hard to explane but i took out my valve spring and screw thinking i would modify my screw (cut it) and hauled out my backup spring and saw my backup valve screw. the spring was sitting on the screw and i knowticed that the backup spring was sitting on the backup screw and i said 'huh thats funny its stayed on there all that time' then i knoticed that the backup screw had a tab on it that one would think would act as a stop for the valve.

i think that everybody should check their valve screws and springs to make sure this tap kinda thing is there and if its not and it is on you backup screw throw it in there and c if it changes anything

hopefully this will fix some problems

sharps

[Trigga Nometry]

That (the screw that was not in the kit to begin with and is not threaded the entire length of the screw) is the "fine tuning" valve screw that Evolve mentions in there instructions. They say it is more time consuming to set-up with the fine tuning screw but you should have even more control over the kit when using it.

[sharps990]

rats

i thought i had sumthin there that would make it easier on ppl

sharps