triggers

[crashdan]

i am looking to replace the stock trigger in my 2k lcd, i was wondering how to remove it, i cannot figure out which side to push the pin out of, thank you for any help

[SkeL]

on my gun, the pin came out on the side of the LCD screen. make sure u put the pin back the same way you took it out, dont reverse it

[WarpedKid02]

Yep, it comes out the LCD side. What I do is, take a nail and hammer on the sidewalk so you will flatten the end of it out. Then take to the opposite side of the LCD screen, and knock it out. As skeletar said, don't reverse it.

[SkeL]

Dont lay it down on the sidewalk, it will scratch the side of your marker. Lay a cloth down over the corner of a desk, set your marker over the corner,and start hammering away. On mine, I had to hammer pretty hard, so dont be a wuss. Hope it works out for you. :moon:

[WarpedKid02]

skeletar, I am talking about hammering the nail on the sidewalk, not the Angel. I was saying that if you hammer the nail into the sidewalk, it will make the end point fine, and not pointy.