Can you use a Speed ram in a LED?

[effbee]

I have a very slight leak from the back hole on the site rail, I think it may be the ram. So can I take my ram out of my Speed and try it in the LED to see if thats the problem?

[mearleman]

i dont think it would work. I think the speed body is smaller(length wise) than the led is.

[Crazy4Paintball1]

Mearleman is right, the speed ram will be smaller. You can use an LCD one though. If you have a slight leak it is more than likley just an O-ring on the ram that needs replaced. Just take it out replace the o-rings put some Angel Grease or Dow 33 on the O-rings and shaft and then put it back in and you should be good to go.

[Outerice]

remember the 14 way valve is above the ram. so it could be the 14 way and not the ram

[Crazy4Paintball1]

That is possible too. Change the O-rings on the ram and if that doesnt work then its the 14way so then you will need to change the o-rings on that...

[crashdan]

no teh ram is shorter on the speed..... so is the solonoid

[Arctic_Wombats]

The LED dwarfs the Speeds. It is almost always O-Rings, I have probably close to 100K on my LED and I think its still the original ram.

[effbee]

Well this all started when i replaced the brass hammer with a ss. I've replaced the 3 o-rings on the ram and the snap ring o-ring, still have a little leak, the ram shaft doesn't look at all scratched from removing the brass hammer, how small are the tollerances for the shaft? or if it matters?

[hgroberts]

ya my led ram broke and I am useing my lcd ram