Runnin high preset tank

[pimpsta05]

On Friday I was runnin on a Worrgas Peanut tank thats high input. I noticed after adjusting to a certain point the minireg wouldnt turn the velocity down any more. Do you have an idea of whats up with it or is is just stopping at around the 300-350psi range

[RiceSolja]

On Friday I was runnin on a Worrgas Peanut tank thats high input. I noticed after adjusting to a certain point the minireg wouldnt turn the velocity down any more. Do you have an idea of whats up with it or is is just stopping at around the 300-350psi range


angels are usually used along side with low pressure output tanks. the newly designed minireg on the 05 spped allows you to use high pressure. rumor goes around saying that if you use a high pressure output tank, then you will have a hard time getting under 300 fps.

john

[acidrain2124]

i can get mine down to 210

[rob05speed]

Just get a LP and you will be fine i had the same problem.

[pimpsta05]

ya im getting a low preset crossfire once I sell my tank

[jish]

ya im getting a low preset crossfire once I sell my tank

Could you change out the spring inside your Worrgas tank to a low pressure spring?

I just did this with my ACI Bulldog tank. They sent me the spring ($5) and I replaced it. Went from 850 psi to 450 psi in 10 minutes flat.

With my HP tank (without minireg mod) though I was able to get the pressure down to 290 for outdoor use. I'm told that some guns just don't go down that far without LP but most should with no problem. Every gun is different. It is best though to go with LP.

[TrashDoG]

That's what Ive been told is a mcuh easier way to get a LP tank then selling your old one (the spring thing) Much cheaper and you get to keep your tnak

[pimpsta05]

Well its gonna cost me more to get the lp tank because I have to sell my tank for cheap but my peanut tank is too close anyway and I want a 68ci