I made a BOOBOO

[AngelDust227]

ok guys here's the deal. I was cleaning my gun when i left the game and i forgot to put the bolt back in. It chopped everywhere. It got inside the breach were the ram is. How can i clean it and is there anywhere for the paint that is in there now to go or is it stuck in that little compartment? NEED HELP ASAP. TOURNAMENT IN A WEEK.

[pfmspaintballinc]

you are going to have to take off the back cover and then take out the ram thru the back. check your mannuel it should explain how to do it.

[shakeydounut87]

yea, just take out the ram and the front cap, and clean it with a squeegee and re-lube and re-set. look in the WDP manual. i believe it has it all there, and if you still dont get it. pm me, i'll help you step by step if you really need it.
hope i helped.
larry-

[Luzrd]

yea, just take out the ram and the front cap, and clean it with a squeegee and re-lube and re-set. look in the WDP manual.

this is what i do, youll also have to remove the gripframe to pull out the pin that holds the valve in place. then you can run a clean squeegie through the entire tube, and clean it completely out.

[Crazy4Paintball1]

Lots of Cotton Swabs (Q-Tips)...lol I would take it apart and clean everything, but if you are ever at the field and something like that happens I always carry a bunch of Q-Tips, they are great for cleaning just about everything that has a tight fit. Great for halo's as well cleaning the eyes and such...

[MadSpeed]

When was the last time you took the whole thing apart anyways? Might be overdue to clean, grease, and oil.

Have fun cleaning, and dont strip anything... bad move if you do.
Good Luck

[welted]

just an aside question: without a bolt how did you chop? i'm guessing it wasn't chopping but rather breaking balls that had rolled back into the breech as they fed. then broke when you fired. this is the only scenario i can picture happening...

[Crazy4Paintball1]

Yeah, I think thats what he meant.....

[AngelDust227]

Ya guys im new to angel's i just got it like 3 weeks ago. SOoooooooooooooo im still new and i appriate all the help you guys gave me. I just took some Q-tips and cleaned that area out without taking it apart. I dont really feel comfortable taking it apart by myself yet. But the good thing is the paint got in my egg and I can now take that apart with no problem lol.

[welted]

see, learning... steps in the right direction... :)

[Crazy4Paintball1]

Yep thats how I learned most of my stuff, but just taking things apart when I had to. Depending on how bad the breaks were and how much got down by your valve, hammar, ram and all that stuff, you might want to have someone take it apart for you and clean it, you don't want to run into any problems in the long run.