Drop forward screw Config for Fly

[WarChamp]

Just bought my new Dust Black A4 Fly and i'm getting it set up. I was just wondering if when i'm ordering a drop forward online whether or not I need a certain type of drop forward or screw config setup for it. Also what type of macroline kit am i going to need as far as the 90 degree bends and length of hose. Any imput is helpful.

[outback]

Most of the Drop Fwds will fit. They usually have a few sets of holes for the different markers (in line holes (angels), and staggered or offest holes. There are a few however that fit Spyders that have the holes side by side, you just want to avoid those. The length of Macro-Line depends upon quite a few factors, such as drop fwd length, and routing. If you get a drop fwd with an air on/off then usually you just need 1 90 degree and about 6 inches of hose (then trim to fit), when coming out of the side on a drop you will have a joggle in the macro-line since the reg inlet is out the bottom... Also it is quite helpful to have the grip cover off when screwing in a drop for the first time to make sure the bolts do not penetrate too far into the marker and would touch anything.

Just my two bits.

[guest1337]

yea what he said