pin???

[hgroberts]

well I live no were near a master tech but my local air§§§§h is close to it so my breach pin will not come out no one can get it out so (this was real stupid ) I take plyers and a rag to it the intire pin comes out and I notice a small hole my airsmih sayes a pin goes ther does this sound right?

[Crazy4Paintball1]

I am a little confused...why wre you trying to take out your breah pin? Are you taking your gun apart or something?

[Holysokz]

IF your talking about the pin that releases the pin from your roto breech. you don't need a pole you need a spring. Just a question though but your talking about the pin that lets you open your breech?

[hgroberts]

ya I am not trying to take it all the way out but it happens

[Blackadder]

Had the same thing happen to my eclipse there is a small rod or pin that is 90 degrees to the breech rod this is there so the breech rod cannot be completely pulled out of the marker. If you can pull the breech rod completely out you have broken off the small rod.
Take a look at your breech rod you can see the place where the pin used to mount in the rod. You have to remove your back plate and take out the spring not needed any more this spring is about the size of one used on a pen.Save it in case you want to replace the rod with a new one. Second step is to find the pin and get rid of it. Good chance that if your rod is that hard to remove it is in the bore for the rod as this does not have alot off room to play and its contacting the rod as you try to remove it. when you get rid of the pin check your breech rod to make sure its still straight as a slight bend in it can make it hard to use if straight you should be fine to continue to us the marker with the only problem being the rod can completely be pulled out of the marker. Hope this helps.

[hgroberts]

thanks a bunch