cobra flat trigger

[Ekim]

I am having problems installing it. Can someone break it down to me. It seems like the top part of it is too thick to fit?! I probably just dont know what im doing.. thanks
Mike

[Syentific]

Originally posted by LordTauk
Take off the gripframe first, two screws front and back with a 3mm allen head (metric)

gripframe should just come off right then and there, WATCH though, there are wires and there is only a certain amount of slack you can move around the gripframe, but there is enough so just be really careful and take your time

I'd take the spring out next, dont have to but incase you'd loose it...

then there is a silver pin that goes through the trigger, there will be a hole on top of the DYE reverse you just bought, on the frame take something smaller or close to the same diameter of the pin and then take something like a hammer or something hard you can knock the pin out with, I think the pin is supposed to be come out on the side of the frame with the LCD screen, just make sure you install the pin the same way it came out once you figured it out.. because if you install the tapered down end reverse Im pretty sure your pin that holds the trigger in play can easily walk itself out and you'll loose it while you're playing or soemthing sucky like that might happen

If you need more help, check your manual - its a really good manual and it tells you how to do everything in a nutshell, basically - that is if you have a manual, if not there is downloadable one on here (Manuals up top)

Any other questions? ask away

This is a perfect time to fine tune your search tool skills. :flipoff:

Good choice in triggers by the way. :clap: