adjusting the hammer

[crashdan]

my hammer sits too far back, when i open the breech, the hammer moves toward the back of the marker, thus not allowing me to close my breech unless i redas it, could anyone tell me how to adjust this? i am new to messing with angels so i wanna do it right and not mess anything up- thanx much

[C.Carles-AOG]

explain "redas"
either way, open the back plate and adjust your ram by using the tool in the angel tool kit. sounds like you need to turn it in a few turns.

[WarpedKid02]

When you open the backplate watch out for the spring. Also the ram is in the right chamber, if your looking at it from the back of the Angel.

Using the ram tool (optional accessory) rotate ram assembly clockwise until slight resistance is felt in opening the breech block. If rotated to far will not open, so rotate the ram assembly counter-clockwise and repeat operation.

[crashdan]

sorry, "redas" meant degass sorry, wrong fingering

[C.Carles-AOG]

Did you get it fixed? Order the parts kit already would ya!? ;-}~