Code 3 on my angel?

[WayneA]

Have question about my angel. It is giving me a code 3 and won't go live. Is this due to a bad battery or what? Thanks as all of you know I have shot a mag for years.

[RgMekanic]

possibly bad, might need to be charged, but usually when you get codes 3 and 4 it means you have a bad board...sorry bro.

[nooblighter6]

yo man i jus went through that with my 2k lcd and i had 2 have a board swap. it's more likely a bad board than not. remember always keep a charge in it cause supposedly lettin the batt go dead kills the boards mem. good luck man

[WayneA]

how much do they run?

[nooblighter6]

at my local proshop with labor it was close to $200 :-\

[DarkHope]

at my local proshop with labor it was close to $200 :-\

Youve gotta be kidding me...You got ripped hardcore. Its not to hard to replace a board, also you could have gotten a used A4 board wich rips hard for 85$.

[thog94]

Youve gotta be kidding me...You got ripped hardcore. Its not to hard to replace a board, also you could have gotten a used A4 board wich rips hard for 85$.


In order to put and A4 board in a LCD you will have to mod your grip frame.

[WayneA]

ne one know where to get one cheap?

[thog94]

Try the classifieds or our sponsors.

[FencerSMS]

ken crane swaps boards for 120 i believe - he runs performance angel i believe - hes located on CAPE COD though, i dont know where that is compared to you