What am I doin wrong?

[Janz]

I played with my LCD this past sunday...I have no clue what I'm doing wrong, can someone please help me out. The problem is that non of the paintballs I'm shooting seem to be going straight. I was using PMR's marbleizers. The balls were going all over the place. They were curving soo bad that I was able to hit a player while they were behind a wall...the ball curved & hit him...It looked liked a guided missle but that one was my only hit throughout the game...What should I do...Is there something wrong with my LCD? :dunno:

[Talfuchre]

I think this has WAY more to do with the paint than the barrel. Clean your barrel out very well and then try different paint.

Also check your ball detent and make sure it is okay.

TF

[crashdan]

make sure there is no paint in your loader and feed tube, as well as in the breech

[slinkyonrampage]

yea definately try another paint, and make sure ur barrel is ok, and also make sure there rnt any breaks inside the breach, hopper, or feed tubes

[DarkRevolution417]

My advice is to :piss2: on PMI paint. I use a secret formula for super cleaning my barrel. Get water somewhat hot and pour a liberal amount of Crown Cleaner into it. Then put your bolt and barrel in it and let it sit for about 15min then rinse and let it dry. Also LoveJuice on your bolt and ram would likely help.

[Maxpayne2k4]

My friends Angel speed was having the same problem, his also was shooting paintballs with very little pressure bieng directed threw the barrel.
Theres a special square looking Oring inside the chamber that directs air passage on the top of your breech chamber. Take a look to see if you still have one. You could have shot it off with normal wear and you probably never dropped a bit of oil on it and the rubber dried up remember to always take care of your gun. i bet you also kept playing with it thus making things worse.
first off if this is the problem bring it to a tech either mail it to one of the techs here or look for an angel tech near where you live. theres tons listed in the back of your manuel and on the internet.or just call local shops and see if they have them
if thats not the case then you better pray its not anything to do with the selinoid.

[Maxpayne2k4]

if it is paint believe me its not RPS's Fault unless you picked it up off the floor. once you get a single chop thats it your done get out and clean it. or if your just that good stay low have your team lay down massive fire while you bust out a squeege from your cargo pants. and try to get back before your team runs out of paint and every1 gets toasted also let every1 know your situation so no one advances on your side thinking they have cover fire. remember communication is key to success.

[DarkHope]

You more than likely just had a bad barrel to paint match...a new batch of a different brand of balls and im sure youll be good to go.

[Emmit]

My advice is to :piss2: on PMI paint. I use a secret formula for super cleaning my barrel. Get water somewhat hot and pour a liberal amount of Crown Cleaner into it. Then put your bolt and barrel in it and let it sit for about 15min then rinse and let it dry. Also LoveJuice on your bolt and ram would likely help.
Negative ghost rider that pattern is FULL!!!!


Never oil your bolt, and certainly NEVER soak your bolt. This ain't your daddy's Cocker boy!!!



Okay all joking aside now. No you should never oil or even worse soak the bolt. Just don't do it!

[Talfuchre]

I think Dark Revolution knew this Emmit. I am thinking he thinks that is funny.

TF