another air problem

[///M3]

well i got shot in the front reg... and i didnt think it would do anything... but now i cant unscrew the pressure screw... and the thing that holds it starts moving.. and now i can push the thing in and you see paint in it... do i need to get a tool kit and like take it apart and clean and relub? or do i need to just sned it in and get things replaced?

[Emmit]

I'd recommend the tool kit. It's got the double pronged tool that allows you to unscrew that section.

[ir3-a.i.r]

Hey I was wandering if it is hard to pull the reg apart I am decently Mechanically inclined but I have never taken apart a reg. Is the tool kit almost required to pull apart the a.i.r.

[Emmit]

it's actually relativly easy to pull the reg apart, you just need the right tools. There are plenty of diagrams in the manual, and even a decent diagram on the box of the tool kit

[ir3-a.i.r]

Ok so I pulled apart the guide manifold (by hand) and the three o-rings seemed to be in good condition I also pulled out the low pressure spring stack and everything seemed ok did I do anything wrong and are there any other o-rings you would suggest checking in the reg.