faster

[tcrcpaintball]

how can i get my angel shooting faster i am only getting 14 bps

[IwanaANGEL]

get some eyes
check out:http://www.angelforce.tv/conversion.html

[bulldog2k]

get some eyes


That's not true - in fact the only thing eyes will do is slow down your rate of fire, not increase it. They prevent chops, not increase your BPS.

The only way to increase your BPS is to practice, I'm afraid... Make sure you're doing it with air to get a true figure, not just dry firing without gas

[RonnyMcDYO]

What I wannaAngel was trying to say is get the MT mod, which gives you eyes and a faster board, therefore increasing speed without practise and no chops, but bulldog is also right, practise practise and more of it. When I got my IR3 I could hit a mere 13 bps, now I can hit 17, just takes time.

[DarkHope]

buy an A4 board for like 85$ at angelservicecenter.com...youll go from 13bps to 23bps easy

[Voloc]

I just got my A4 board today and i went from 13 to 24 A4 board really kicks ass

[mamba_juice]

if you really wanted to get technical, we could break it down into mechanical workings and how to improve the mechanical operating system in general....but those arent bolt on upgrades so we'll stay out of that.


the two eaisiest ways to make your gun faster have already been mentioned, practice and a newer board without a cap....doesnt matter if it's an angel board, a timmy board, or a dm4 board....they all do just about the same thing.

[DarkHope]

great to hear your happy with the A4 board =)

[bkerstett]

how hard is it to install one of those a4 boards?

[Emmit]

how hard is it to install one of those a4 boards?
it's actually quite simple...it's just a couple of screws and some wire plugs and you'er done.

[Voloc]

yeah its very easy to do just gotta adjust the trigger a little afterwards, took me maybe 10 mins to do it all. Got a softface bolt with it too and i cant wait to use it this weekend.

[WDP ir3 2k3]

it's actually quite simple...it's just a couple of screws and some wire plugs and you'er done.

if you get a a4 bord do you need to get new batters?

[nonamifrontman]

I dont think so, someone said theirs is fine with the ir3 battery. What you could do though is buy the Speed/A4 charger for the Ir3 battery. You can charge a higher voltage battery at a lower voltage so the A4 charger (4.8 volts) will work fine on the Ir3 battery (6 volts). Im not sure how long the A4 board can tolerate 6 volts, or if it will work fine.

[Voloc]

Should i not charge my Ir3 battery with the charger i got with it? Am i going to need to buy an A4 charger?

[TheJoker]

Dude you should have just get a trigger job I can reach 18 bps. But takes it's toll on my hand. Talking about arthritis. Before you or anybody go out to buy expensive mods try playing with your gun and experimenting with it.