angel lcd jam bolt not working

[rocker4488]

bought a jam antichop bolt with high aticipation.. sure it dint chop the ball by goung through it... but the insane blowback made hy hopper look like a blender.... um.. i reset the ram and everything.. everything is as it should be.. belive me when i say this.. the botl works fine shooting normally but when it does its pinching motion it has an insane amount of blowback.. its the not detente... allready tried messing with that.. i dont know the full operation of thebolt.. but isnt it supposed to seal off when it does its antichop thing? ne suggestion? help? anythign will eb appreciated.. thanks

[mamba_juice]

your going through exactly what i thought would happen...the pressure in between the bolt and the ball pushes both back, the ball still goes out but the bolt is pushed back in the process and air is vented up the feedtube.


i'm guessing that you had a pretty good decrease in velocity when you put it in, right?

[RgMekanic]

I'm NOT Impressed with the Angel JAM bolt, friend had the same problem all day when trying one...switched back to his shocktech and everything was peachy.

[monkeymanlcd]

I have one of them. It worked great form awile,then one day after I look in to the tube where the hammer is I noticed alot of wear by by valve that wasnt there at the at the start of the day. I figured out that when my bolt stoped on a ball it actally pushed my hammer down and cause alot of wear on my gun. I sent my gun away to see if the wear if gona hurt my angel at all, I hope not.

[rocker4488]

hmm aight.. time to yell at them then.. lol....