I really need help with my ir3

[pbfanatic101]

Ok, my gun will not shoot over 200 fps, i have a gladiator reg with a 800 psi output tank on there i cleaned out the ram and valve because i copped some paint. The lpr is set pretty much as high as it can go around 110 psi i think.
so why wont it go any higher?

[warpedx]

Might want to look into replacing your valve stem, that can cause low fps if it's worn out and sticking. Make sure you dwell is set at 14, and try cleaning your mini-reg too.
Actually, reading that you cleaned your ram, definitely check the snap ring setting first.

[pbfanatic101]

i have a gladiator reg on there, and what valve stem are you talking about. It has only been in use for less than 3 monthes so i don't think anything could be worn.

[tcrcpaintball]

put 1 or 2 shims on the lpr i had the same problem

[WDP ir3 2k3]

my gun was doing that be for i olny could get 260 Fps and then i just Moive mast around with my valve then it workt

[RonnyMcDYO]

Sounds like your snap ring is not set right, read the manual on how to do this then you should be fine.