IR3 velocity problems

[SPIKE]

:cry: ok so my mini reg is clean and working well<500 psi into the gun, lpr 105psi :cry: (wow that's high) but it's all I could do to get my velocity up to 250 :pisss: (wow that's low). so what needs to happen?

[jb12]

What's your dwell at? I would recommend a dwell of 14. Also, check your ram to make sure it's set right and check your snap ring to make sure it's set right. If that doesn't work post again and we'll help you.

[warpedx]

Might also need to replace your valve stem.

[DarkHope]

whats your output on your tank set at?...is that what the 500 is?...if so IR3s need around 650psi at least going in

[DarkHope]

"The ANGEL iR3 is designed to operate on airnitrogen gas. This needs to be supplied to the ANGEL iR3 at a regulated pressure of 700psi(48 BAR) using a suitable first stage paintball regulator, such as the ANGEL A.I.R."

I run my IR3 at 650psi with a volumizer, and its fine...so that may be your problem...

[RonnyMcDYO]

Yea man you need to put more then 500 psi into the gun, unless you have a gutted mini reg and some kind of high end adjustable reg, like max flo or angel air. 650 is a good pressure, I run mine at that and I get mine wherever I want it.

[Assault]

I ran mine on 450psi and was still able to get 300fps. but that doesnt mean every marker will run on that.
Turn it up and see what happens.