slayer trigger mods hlp!!!

[Sumala]

:madd: What mods would i have to make to use the Fly force slayer trigger on my IR3

[RonnyMcDYO]

From looking at an A4 trigger and an IR3 trigger the only difference I can really see is there appears to only be one pivot point and the Ir3 has a small extended piece on the back end of the trigger. Looks like it would work but hard to say, I dont have an A4 trigger.

[jb12]

You need to trim some of the extra material off the top, and drill holes in it so you can put screws in it to adjust the trigger. Those are the big two mods, however there might be some smaller mods you need to make, not sure on exactly what else.

[RonnyMcDYO]

ah that would make sense since the A4 trigger is adjusted differently. Why do you want the slayer trigger? isnt that a flat one? Cause if it is just get the Cobra Fang Trigger its a sweet trigger and looks real nice in chrome or the ss whatever it is, the shiny looking one =P

[nonamifrontman]

Im in the process of making some slayer triggers for an ir3 now, ive got like 5 or so cut I just need to shape them a little more then hopefully get them annoed.

Ill post pics when I get some made.

How I did this:
I took my cobra trigger and traced the top half (with the trigger pin holes, set screws, leaf activator etc) then took the slayer design and added it onto it. Then cut them out with a bandsaw, shaped them using a bench grinder and a dremel to make them smoother and look better. After I do all the finish work im gonna tap set screw holes and drill a trigger pin hole, I just need to find a drill bit the same size as a trigger pin.