How Do you lower your FPS on Mini Reg

[jayr7309]

I have a LOW PResure tank

I took my Force 4 apart and now the mini reg is reading at 400, I tried the allen key to lower it but no luck, How do you lower it. It was fine until I oil and grease every O ring up, THANKS

[tgaffner]

If using the Allen Screw on the side of the Mini-Reg doesn't work, did you assemble the Mini-Reg right?

[jayr7309]

I never took the minireg apart out, I oil the the minireg with 2-3 drops of oil and it lowered to 300, now it's at 275,

Will this pass CHRONOgraph, are the numbers on the minireg gauge the same as the CHRONO readings.
Will I be safe at 275

What are other peoples gauge located at?

Does the LPR need oil too, I wonder?

[firemedic30]

I am the opposite. I have a preset LP from Crossfire. I have to have my mini-reg in the orange to get to up to 290???

[tgallo]

are the numbers on the minireg gauge the same as the CHRONO readings.


NO.
The chrono measures how fast your balls are travelling while the gauge on the mini-reg measures the the air pressure going into the gun from the mini-reg.

[Jouster]

After you adjust pressure on the mini-reg with the hex key hole, you have to shoot the gun a couple times to clear out the old air and reset the gauge.

Jouster

[KEN CRANE]

I have a LOW PResure tank

I took my Force 4 apart and now the mini reg is reading at 400, I tried the allen key to lower it but no luck, How do you lower it. It was fine until I oil and grease every O ring up, THANKS


if you took it apart and its now reading 400fps something was installed incorrectly.if you are using a low pressure tank that shouldnt be poss.also its not good to oil the mini reg as it just gunks up.

[jayr7309]

Thanks guys, But I had an OIL service recommend message come on and wondered how to fix the problem.... MT BOB said

fixmyangel
Site Admin



Joined: Nov 05, 2003
Posts: 356

Posted: Tue Jun 22, 2004 2:58 am Post subject:

--------------------------------------------------------------------------------

Unscrew the minireg, add 2-3 drops of oil and screw back on. Open roto-breech, add 1-2 drops of oil in the air passage (round hole) and clode roto-breech. Now gas up the marker (without barrel, hopper or paint etc...), place a towel over the barrel port and fire the marker 30-40 times. When done turn off air, degas marker and open roto breech. Remove bolt and whipe dry. You are all done. The oil service will not go away until you press the bottom button to clear the message.

Back to top