n00b

[bnaka]

heres a newb question for u, my breech wont open, whats wrong? it might b the bolt in the way but i havent had the problem before?

[AngelBoi]

EZ. Here's a hint...

Try pulling ur Knob back as far as it can go, and then try to open it. If it doesnt work, Screw the Knob clockwise. Every time you complete 1 360 degree turn, put it in the unlocked position and see if the breech will open.

If you get it in too far, and it starts to scrape on the annodizing, then its the ram.

Take off the back plate, thus the knob, open the breech (it should open with no cocking knob in there) and use the Ram Removal Tool/2 small allen wrenches to remove it. Pull the ram out, and screw it back in slowly. Look at the Bolt's little metal spike on the underside, and try to align the ram's hammer (front part of the ram) to the spike. It should "click" or slide in when its right.

Justin

[twitchytrigger]

Well, I'm still new to angels myself, but I would imagine it's either the breach knob rod (if that is what you call it) or the hammer/ram has adjusted itself forward just a bit. I would take off the back plate, remove the rod, and if it still can't open, try slightly adjusting your hammer/ram.

[bnaka]

thanks angelboi but as u were replying i took off the barrel and pushed back the bolt with my finger and then it opened, but thanks anyway dude.

[twitchytrigger]

LoL, oh well.

[AngelBoi]

rotflmao