is it worth it?

[speed_ster]

i am thinking about getting an angel speed very soon but the problem is i already have a n2 tank with a high pressure output. i already read the thread on how to change the regulator to accomidate high pressure tanks but how hard is it to do that operation??undefined

[thog94]

Changing the reg shouldn't take you more than a minute or 2, all you need is a pair of cir clip pliers.

[speed_ster]

i dont think i have any where can i buy them like any hardware store?

[AngelSpeeD2004]

Well if you r troubled and unsure of what to do when you first open the mini reg ull probably b like this..... :dunno:

It will take quite a while to do this operation.

You can mod the mini reg to lower the spring stack.

First let out all the pressure to your gun.
Now take off the mini reg on your gun.
Remove the Circle c clip with a pair of pliers.
Flip the mini reg over n tap in on a soft surface.
Take out one of the cupped washers out of the mini reg stack.
And put your mini reg back together.

This stunt takes for ever (it took me 3 hours 43 minutes and 38.14 seconds to do) if u mess up you will b like this..... :wall:

So take your time n good luck.

[thog94]

Any hardware store should have them, I know that Sears carries them. Make sure you get the correct kind, they have pliers that remove inside and outside cir clips and you would want the ones that remove the inside clips.

[speed_ster]

thanx alot

[speed_ster]

speed 2004 wtf is wrong wit u man

[AngelSpeeD2004]

my bad my bad not regular pliers bro u need the circlip pliers.....yea thats the ☼☼☼☼

[AngelSpeeD2004]

theres nuffin wrong with me heh.....