Totally F***ed up

[AnGeL ShoOtEr90]

I was showin my friend my lcd and he dropped it. And the breech broke flush off the back of the gun. So what can I do to get it out.

[IwanaANGEL]

you mean the breech Knob???

[SKAN]

droping angels is very bad... your friend should be pimp slapped... HARD..

[bobjim]

Make him pay for it....or better yet if he is as young as you tell his parents that your gun cannot be fixed and make them buy you a new one. lol

[dark2k2LCD]

you must mean breach knob, because i doubt the breach itself broke off.

anyway, get some pliers and pull out the breach pin (its spring loaded) then put a new knob on the threads

[psychoballer07]

well if he said it is flush with the back i doubt pliers are going to help, your probably going to have to take off the back plate and get the rod out that way, be careful though cuz like stated above its spring loaded and the spring has a tendency to shoot out if your not careful

[IwanaANGEL]

yes, you have to take out the backplate, and get a new breech rod and Knob

[AnGeL ShoOtEr90]

the breech rod is broke and i cant get a good enough grip to pull it out is there anything else i can do

[drkanglr]

Take the backplate off, watch to make sure you get the spring. Once the backplate's off you can get the breech rod out. You will need to buy a new breech rod (any of the sponsors will have 'em). Your old knob may still work, if you can get the piece of rod out of it. If not, you'll need a new breech knob, also.

[AnGeL ShoOtEr90]

I cant get anything like pliers or nothing to get out the broken breech rod

[MoogLe]

I cant get anything like pliers or nothing to get out the broken breech rod
did you do what these guys suggested??? taking the backplate off??

[AnGeL ShoOtEr90]

yea if you could only see it, it broke off inside the body

[Ted Lesiak]

stick something through from the otherside then with the back plate off and push the friggin pin out!

[SKAN]

what if he cant open the breech??? that means there is no way for him to push it out from the inside... :rrrright:

[Ted Lesiak]

your right but if he has the back plate off and the spring is gone he might be able to stick a common pin in the breech crack and work it out (my 2K has a big enough gap) he does say he can't get a "good enough" grip so Im assuming its sticking out a little. poke the side of the shaft with a pin and put some force towards the back and see if you can move it just enough to grab it with pliers.

[MoogLe]

u could try sawing a small slot on the exposed part of the pin on the right side of the breech and then try pushing it out a bit with a screwdriver or something,

just hope it didnt bend inside the body, if that's the case well.... it's gonna be a bitch