High Output Pressure

[lcdfronter]

I have an angel air that when i roll it goes down to 450 psi then about 5 min later it goes to HI-P. what do ya'll think is wrong?


:pui:

[t2zone1]

I have an angel air that when i roll it goes down to 450 psi then about 5 min later it goes to HI-P. what do ya'll think is wrong?


:pui:


in my not so great opinion, i would say that it may need to be recalibrated!! ..... but perhaps one of the users or techs on the site can give you some better advice!! good luck friend!! :blasting:

[Emmit]

it sounds like you've got what's called "reg creep" you've got an o-ring or 2 that are scored and need to be replaced, worst case scenario your main seal may also be bad. First things you should check would be the rocket o-rings.

[ZiPpO41189]

its all o-rings with leaks. ps- make sure that you empty out your tank first before doing any repairs, you'd be suprised on how many people woulden't think i would matter!

[lcdfronter]

Thanks. Also when the gun is charged with my pro connect it loses all the air in the tank in about 5 hours. that is an o-ring but i dont know where to start.

[ZiPpO41189]

first, take off your tank from the reg, making sure that there is no air in it. unscrew the cap on the front using either 2 allen wrenches, a ram adjustment tool, or snap pliers. once you have that unscrewed, you will see a gold tube with your adjustment screw in it, with washers around it. remove the washers and note the order that they are it. next, just pull out the tube very carefully. you will notice that it is actually part of a valve. remove the smaller tube on the back of this. It pulls out too. replace the o-rings on these where needed. continue to replace the o-rings further in the reg, and oil and lub where needed. follow the attached diagram and if you have any more question feel free to e-mail me at Zippo41189@aol.com or hit me up on aim. I hope this helped you!!!