mamba_juice
06-08-2004, 11:08 AM
i see that people have tried to get rid of the problem of the breach o-ring not sealing. after about 20 minutes of molding and applying some liquid gasket (pictured below) i got it to perfection. i evenly applied about an extra 16th of an inch on top of the o-ring, let it dry. when i took it to the chrono with my robert hernandez bolt beforehand it read 275 275 274 276 277. after i applied this and let it dry, the velocity jumped to 303 301 304 303 302. i shot about 500 rounds through it, and there is no noticeable bolt wear.
the reason there's no bolt wear is because the gasket material is just soft enough to seal it perfectly and prevent the bolt wear that everyone has had with other methods. it can be found at your local home depot or ACE. it is made by loctite, ultra blue RTV silicone gasket maker. i used an allen wrench to apply it and a Qtip to clean it up.
i am not responsible for you breaking your gun, i dont know how you'll mess it up by doing this but some people are just morons.
the reason there's no bolt wear is because the gasket material is just soft enough to seal it perfectly and prevent the bolt wear that everyone has had with other methods. it can be found at your local home depot or ACE. it is made by loctite, ultra blue RTV silicone gasket maker. i used an allen wrench to apply it and a Qtip to clean it up.
i am not responsible for you breaking your gun, i dont know how you'll mess it up by doing this but some people are just morons.