Cops2 senses everything at every setting.

[K4S]

Before i start, i have mem6 cops2, BAS was set at 7. Okay, I was trying to set up cops the way the manual described and i found something odd. When i put it at sens 12 and dry fired it would have delays as if wasnt sensing a ball. Shouldnt it think there's always a ball in the chamber since its at sens 12, the most sensitive setting? Anyway, I then tried sens 1 and dry fired. Same thing with the delays though this is normal since its the least sensitive. I then tried it at sens 2-11, same thing. End result, All modes of sens detected no ball when i dry fired.

Next, drop tests. I put sens back at 12 and of course all balls passed the drop test (15/15). I then put it at sens 1 and did the drop test...it passed 15/15. I again tried the drop test with sens 2-11 and they all passed. I put it back at sens 12 and ran my finger gently over the cops rod...pass. I put it back at sens 1 and ran my finger over the cops rod...couldnt get it to pass. This led me to think that my cops sensor is working but at a margin where all setting are sensitive.

I'm quite sure my cops sensor is fine because i've only played 1 days since i got it back from the techs who replaced my old cops sensor. I havent used a straight shot squeegee, only a battle swab and i was careful not to hit the cops rod doing so.

Im not really sure what to do...i dont think its very normal though.

[KIce]

Whats your CMROF set at?

[K4S]

set at 20 but that shouldnt affect anything.

I just looked though and the small strip in the sensor appears to have a hairline crack down the middle...but wtf how could it crack when im using an egg2 and all i've used is a battle swab and i was careful not to hit the rod.

[Hep]

Rod might need a slight sanding down if its too far into the breech but thats pretty rare or your cops pad is bad? Just a suggestion on what to look for.
Hep