Trigger no longer activates 'noid

[nitro_cs]

After removing the grips from my IR3 and taking the LCD out to adjust its orientation, upon re-install any trigger pulls no longer activate the 'noid. There used to be an audible click when the trigger was pulled in live mode and that is now absent. I tried pressing the orange button on top of the noid and still no click. Is this indicative of a bad noid? Or did I accidently fry my board when putting the LCD back in?? Thanks in advance.

[Vantage_TeS]

If the orange button isn't doing anything, its usually the noid itself. Make sure the power connections are snug, and no wires a clipped or anything like that. Since you didn't take the noid out, its probably just wiring. Sometimes the wires can accually pull out of the bottom of the noid.

Oh and make sure that all the plugs are in the right spot. Thats a big one :bigone: (god I love you matt).

[ricecrispi]

http://www.angel-owners.com/showthread.php?t=23839

Check out this thread as well. Same topic and on the same page. You may have rip the harness probably like I did, Doh! God, I should no better. Its like watch porn with the door open.

If you play why the connectors you might squeeze a shot or two. If the orange button doesn't work most likely you'll have to send it out to repair it.

[nitro_cs]

I wound up spending some time to diagnose the problem...seems the wiring plugs to the board had a bad connection. Is there any way to re-crimp these plugs or put new ones on? I dont want to buy a whole new harness just for one plug.

[Vantage_TeS]

If its just loose, take the outside pins and bend em outwards a little < | | > \ /. Should fix the problem. If the accual wires are loose in the connector any electronics repair store would be able to put a new connector on there for you.