angel tool kit? + lpr?

[OneofUsSpeed]

hey i got an issue my lpr is 2 high. and i got an angel tool kit but i dont know how to lower my lpr my setup in an angel speed angel air largest volumizer and a4 bolt. could someone please describe in full detail how to lower my lpr. or should i just wait and let someone who knows how to do it do it

[LionFish]

Most likely some one here will tell you to use the SEARCH,so let me save them the time.DO A SEARCH!!!!OK Ill explain briefly,first did you check your Manual? that will explain it best.You will want to go to page 22,that s where it starts.Open the LPR side and remove 1 shim @ a time. Then re screw the end plug on,then remove the exhaust valve end plug and insert pressure gage,repeat untill desired LPR is achived.Hope this helps.

[acoenfam1]

The gauge goes on the LPR side not the exhaust side. BUt the instruction in the manual are accurate.

[winter001]

:dito: Make sure you put the gauge on the lpr side

[donaldduck]

How do you adjust your lpr in a A4 ?

[acoenfam1]

By Adding/Removing shims